Ничего не куплено!
Продажа и внедрение оборудования для промышленной автоматизации
Mail: prom@protonpc.ru
Тел: (495) 789-41-64 доб. 303
Дискретный ввод | |
Количество каналов | 8 |
Тип входа | Wet Contact (Sink, Source) |
Уровень логической " 1 " | +10 VDC ~ +50 VDC |
Уровень логического " 0 " | +4 VDC Max |
Входное сопротивление | 10 k |
Счетчики | |
Мах. значение | 65535 (16 bits) |
Max. входная частота | 50 Hz |
Mин. длительность импульса | 10 ms |
Защита от перенапряжений | +70 VDC |
Дискретный вывод | |
Количество каналов | 8 |
Тип выхода | Isolated Open Collector (Sink) |
Max. ток нагрузки | 300 mA/channel at 25 °C Direct drive power relay module |
Выходное напряжение | +10 VDC ~ +40 VDC |
Защита от перенапряжений | 60 VDC |
Защита от перегрузки | 1.1 A |
Защита от короткого замыкания | Да |
System | |
Процессор | 16-bit CPU |
SRAM | 512 KB |
Flash Memory | 512 KB |
EEPROM | 16 KB |
Сторожевой таймер | Да |
Интерфейсы | |
PoE Ethernet Port | 10/100 Base-TX (With Link, Activity LED Indicator) and automatic MDI/MDI-X |
2 Way Isolation | |
I/O | 3750 Vrms |
EMS Protection | |
ESD (IEC 61000-4-2) | 4 kV Contact for each terminal |
EFT (IEC 61000-4-4) | +/-2 kV for Power |
LED Indicators | |
PoE | PoE On |
L1 | System Running |
L2 | Ethernet Link/Act |
L3 | Ethernet 10/100M Speed |
Power Requirements | |
Reserve Polarity Protection | Да |
Powered from terminal block | Yes, 12 ~ 48 VDC |
Powered from PoE | Yes, IEEE 802.3af, Class 1 |
Consumption | 4.3 W |
Mechanical | |
Габариты (Ш x В x Г) | 72 mm x 123 mm x 35 mm |
Installation | DIN-Rail or Wall mounting |
Environment | |
Рабочая температура | -25 °C ~ +75 °C |
Допустимая температура в режиме хранения | -30 °C ~ +80 °C |
Влажность | 10 ~ 90% RH, non-condensing |
Functions | |
Rule Configuration Website | Access Web server on WISE controllers to edit and upload logic rules through web browser. |
36 IF-THEN-ELSE Logic Rules | 3 IF conditions with AND or OR operators 3 THEN actions and 3 ELSE actions |
48 Internal Registers | Hold temporary variables and read/write data via Modbus/TCP address. |
12 Timers | Delay / Timing functions |
12 Emails | Send Email messages to pre-set Email receivers. |
12 CGI Commands | Send pre-set CGI commands. |
12 Recipes | Set up THEN/ELSE action groups. |
8 P2P remote modules | Set up the connection information for the remote WISE modules. |
Modbus/TCP Protocol | Real time control and monitoring I/O channels and system status of controllers via SCADA software. |
IF Conditions | |
DI Channel | ON, OFF, ON to OFF, OFF to ON, Change |
Internal Register | =, and lt , and gt , and gt =, and lt = (value) |
DI Counter | =, and gt , and lt , and gt =, and lt =(value), Change |
DO Counter | =, and gt , and lt , and gt =, and lt =(value), Change |
Timer | Timeout, Not Timeout |
P2P | DI, AI, DI counter, DO counter, IR |
Rule Status | Enable, Disable |
THEN / ELSE Actions | |
DO Channel | ON, OFF, Pulse Output |
Internal Register | Change the value |
DI Counter | Reset |
DO Counter | Reset |
Timer | Start, Stop |
Send | |
CGI Commands | Send |
Recipe | Execute |
P2P | DO(On/Off), AO, IR |
Rule Status | Enable, Disable |