PROFIBUS DP/DP V1 Bus Coupler FB8205*
Цена:
ПО ЗАПРОСУ
Получить скидку и купить со склада↓
- Interface between the I/O modules and the DCS/PLC
- Bus coupler for 80 analog or 184 digital channels
- Communication via PROFIBUS DP
- HART communication via PROFIBUS DP V1 or service bus
- Configuration via FDT 1.2 DTM
- Non-volatile memory for configuration and parameter settings
- Self configuration in redundant systems
- Permanently self-monitoring
- Outputs drive to safe state in case of failures
- Installation in suitable enclosures in Zone 1 or Zone 21
Технические характеристики: FB8205*
| Supply | ||
| Подключение | backplane bus | |
| Rated voltage | 5 V DC , only in connection with the power supplies FB92** | |
| Потребляемая мощность | 2 W | |
| Fieldbus interface | ||
| PROFIBUS DP | ||
| Connection | wired to Ex e terminals via backplane | |
| Baud rate | до 1.5 MBit/s | |
| Протокол | PROFIBUS DP/DP V1 read/write services | |
| Number of stations per bus line | max. 125 (PROFIBUS), max. 119 (service bus) | |
| Number of channels per station | max. 80 analog, max. 184 digital (standard configuration) | |
| Number of stations per bus segment | max. 31 (RS 485 standard) | |
| Number of repeaters between Master and Slave | max. 3 | |
| Supported I/O modules | all FB Remote I/O modules | |
| Bus length | max. 1000 m (FOL, 1.5 MBaud), max. 1000 m (copper cable, 187.5 kBd), max. 200 m (copper cable, 1.5 MBd) | |
| Addressing | via configuration software | |
| PROFIBUS address | 0 ... 126 (ex works standard: 126) | |
| GSE file | CGV61710.gsd/gse | |
| HART communication | via PROFIBUS or service bus | |
| Internal bus | ||
| Подключение | backplane bus | |
| Redundancy | via front connector | |
| Indicators/settings | ||
| LED indicator | зеленый светодиод (power supply): On = operating, fast flash = cold start, slow flash = HCIR loading active красный светодиод (collective alarm): On = internal fault, flashing = no PROFIBUS connection желтый светодиод (operating mode): flashing 1 (1:1 ratio) = active, normal operation- flashing 2 (7:1 ratio) = active, simulation | |
| Соответствие директивам | ||
| Electromagnetic compatibility | ||
| Directive 2004/108/EC | EN 61326-1 | |
| Conformity | ||
| Electromagnetic compatibility | NE 21 | |
| Стандарты защищенности | IEC 60529 | |
| Условия окружающей среды | ||
| Рабочая температура окружающей среды | -20 ... 60 °C (-4 ... 140 °F) | |
| Температура хранения устройства | -25 ... 85 °C (-13 ... 185 °F) | |
| Relative humidity | 95 % non-condensing | |
| Shock resistance | shock type I, shock duration 11 ms, shock amplitude 50 m/s2, number of shock directions 6, number of shocks per direction 100 | |
| Vibration resistance | frequency range 5 ... 500 Hz, amplitude 5 ... 13.2 Hz ±- 1.5 mm, 13.2 ... 100 Hz 1g, sweep rate 1 octave/min, duration 10 sweeps 5 Hz - 100 Hz - 5 Hz | |
| Damaging gas | for plugs: 21 days in 25 ppm SO2, at 25 °C and 75 % rel. humidity, device G3 | |
| Физические/механические параметры | ||
| Стандарты защищенности | IP20 (module) , a separate housing is required acc. to the system description | |
| Подключение | via backplane | |
| Масса | приблизительно 750 g | |
| Dimensions | 57 x 107 x 132 mm (2.2 x 4.2 x 5.2 in) | |
| Data for application in connection with Ex-areas | ||
| EC-Type Examination Certificate | PTB 97 ATEX 1074 U , PTB 97 ATEX 1075 (system) , for additional certificates see www.pepperl-fuchs.com | |
| Group, category, type of protection |  II 2(1) G Ex d [ia] IIC | |
| Питание | only in connection with the power supplies FB92** | |
| Соответствие директивам | ||
| Directive 94/9/EC | EN 60079-0 , EN 60079-1 , EN 60079-11 , EN 60079-26 | |
| International Сертификаты | ||
| IECEx approval | pending | |
Аксессуары и комплектующие
| Совместимое оборудование | Наименование |
| Remote I/O System - LB/FB | DTM collection |
Нет отзывов об этом товаре.
Написать отзыв о PROFIBUS DP/DP V1 Bus Coupler FB8205*
Ваше Имя:Ваш отзыв:
Оценка: Плохо Хорошо
Введите код, указанный на картинке: