Оптоволоконный датчик Sick WLL170-2P132 (6029511)
Цена:
ПО ЗАПРОСУ
Получить скидку и купить со склада↓
| fiber-optic sensors | ||||||||||||||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||||||||||||
| Features | |||
| Dimensions (W x H x D): | 10.5 mm x 35.5 mm x 83.7 mm | ||
| Sensing range max.: | 0 mm ... 4,000 mm, through-beam system, LL3-TB02 and tip adapter LL3-TA01 | ||
| Sensing range: | 0 mm ... 160 mm, proximity system, LL3-DK06 0 ... 700 mm, through-beam system, LL3-TB01 1) | ||
| Light source: | LED 2) | ||
| Type of light: | Visible red light | ||
| Wave length: | 660 nm | ||
| Adjustment: | adjustable | ||
| Sensitivity adjustment: | adjustable Potentiometer, 10 revolutions 3) | ||
| Time type: | Off-delayed | ||
| Delay time: | selectable by sliding switch: >=40 ms | ||
| Indication: | LED | ||
| Sensor/detection principle: | Fiber-optic photoelectric sensor | ||
| 1) 3) 2) Average service life 100,000 h at Ta = +25 °C With correctly attached fibre-optic cable LL3 and closed protection hood |
| Mechanics/electronics | |||
| Enclosure rating: | IP 66 | ||
| Supply voltage: | 10 V DC ... 30 V DC 1) | ||
| Residual ripple: | 10 % 2) | ||
| Power consumption: | ≤- 30 mA 3) | ||
| Switching output: | PNP, light/dark-switching, selectable via light/dark selector, open collector | ||
| Output current Imax.: | ≤- 100 mA | ||
| Response time: | ≤- 0.25 ms 4) | ||
| Switching frequency: | 2,000 Hz with light/dark ratio 1:1 | ||
| Connection type: | cable, PVC, 2m 2 m 5) | ||
| Cable material: | PVC | ||
| Number of cores: | 3 | ||
| Conductor cross-section: | 0.2 mm? | ||
| Protection class: | III | ||
| Circuit protection: | A B C D 6) 7) 8) 9) | ||
| Housing material: | ABS/PC | ||
| Ambient operating temperature: | -25 °C ... 55 °C | ||
| Ambient storage temperature: | -40 °C ... 70 °C | ||
| Cable diameter: | 3.8 mm | ||
| 1) Limit values 2) May not exceed or fall short of VS 3) Without load 4) Signal transit time with resistive load 5) Do not bend below 0 °C 6) A = VS connections reverse-polarity protected 7) B = inputs and output reverse-polarity protected 8) C = interference suppression 9) D = outputs overcurrent and short-circuit protected |
Нет отзывов об этом товаре.
Написать отзыв о Оптоволоконный датчик Sick WLL170-2P132 ..
Ваше Имя:Ваш отзыв:
Оценка: Плохо Хорошо
Введите код, указанный на картинке: