Ничего не куплено!
Поставки и внедрение датчиков, сенсоров, систем идентификации и контроля
Mail: prom@protonpc.ru
Тел: (495) 789-41-64 доб. 294
Описание | ||
KE switch cabinet module 4 inputs (PNP) and 4 relay outputs | ||
Основные характеристики | ||
Slave type | Standard slave | |
AS-Interface specification | V2.1 | |
Required master specification | &ge- V2.0 | |
UL File Number | E106378 | |
Показатели надежности и наработки на отказ | ||
MTTFd | 300 a | |
Mission Time (TM) | 20 a | |
DC (Diagnostic Coverage, Диагностическое покрытие) | 0 % | |
Индикаторы состояния и их значение | ||
LED FAULT | Fault display- красный светодиод red: Communication fault or address is 0 red, flashing: Overload, internal input supply | |
LED INT | Internal input supply active- зеленый светодиод | |
LED PWR | AS-Interface voltage- зеленый светодиод | |
LED IN | switching state (input)- 4 желтый светодиод | |
LED OUT | Switching state (output)- 4 желтый светодиод | |
Электрические параметры | ||
Auxiliary voltage (input) | 12 ... 30 V DC PELV | |
Rated operational voltage | 26.5 ... 31.6 V from AS-Interface | |
Номинальный рабочий ток | &le- 35 mA (no sensors)/max. 210 mA | |
Overvoltage protected | O1 ... O4: Over voltage category II UEXT, Ue: Over voltage category III, safe isolated power supplies (PELV) | |
Вход | ||
Number/Type | 4 inputs for 2- or 3-wire sensors (PNP), DC | |
Питание | from AS-Interface (switch position INT, basic setting) or external UEXT (switch position EXT) | |
Voltage | 21 ... 31 V DC (INT) | |
Current loading capacity | &le- 150 mA, overload- and защита от короткого замыкания (INT) | |
Input current | &le- 8 mA (limited internally) | |
Switching point | according to DIN EN 61131-2 (Type 2) | |
0 (unattenuated) | &le- 2 mA | |
1 (attenuated) | &ge- 4 mA | |
Signal delay | < 2 ms (input/AS-Interface) | |
Выход | ||
Number/Type | 4 relay outputs, normally open | |
Питание | none | |
Nominal load | ||
Per contact | 2 A / 30 V DC- 2 A / 253 V AC | |
Per module | 8 A | |
Control circuit | &le- 8 mA per relay (from AS-Interface) | |
Switching delay | < 10 ms (AS-Interface/contact) | |
Usage category | DC-13 and AC-14 | |
Switching | ||
Mechanical | 5 x 106 | |
Electrical | 0.2 x 106 (250 V AC, 2 A, cos &phi- = 0.4) | |
Electrical isolation | ||
Input/Output | safe isolation, rated insulation voltage 300 V AC | |
Input/AS-Interface | Switch position INT: None Switch position EXT: reinforced insulation, rated insulation voltage 66 V DC | |
Output/Output | basic insulation, rated insulation voltage 300 V AC | |
Output/AS-Interface | safe isolation, rated insulation voltage 300 V AC | |
Programming instructions | ||
Profile | S-7.0 | |
IO code | 7 | |
ID code | 0 | |
ID1 code | F | |
ID2 code | E | |
Data bits (function via AS-Interface) | ||
D0 | ||
D1 | ||
D2 | ||
D3 | ||
Parameter bits (programmable via AS-i) | function | |
P0 | not used | |
P1 | not used | |
P2 | not used | |
P3 | not used | |
Соответствие промышленным стандартам | ||
Соответствие директивам | ||
Low Voltage Directive 73/23/EEC | EN 60947-1 | |
EMC Directive 2004/108/EC | EN 61326:2003 | |
Соответствие индустриальным стандартам | ||
Electromagnetic compatibility | NAMUR NE 21: 1998-08 | |
Electrical isolation | EN 60947-1 | |
Степень защиты корпуса | EN 60529:2000 | |
Fieldbus standard | EN 50295:1999 | |
Условия окружающей среды | ||
Рабочая температура окружающей среды | -25 ... 60 °C (-13 ... 140 °F) | |
Температура хранения устройства | -25 ... 85 °C (-13 ... 185 °F) | |
Relative humidity | 90 % , noncondensing | |
Pollution Degree | 2 | |
Физические/механические параметры | ||
Стандарты защищенности | IP20 | |
Подключение | removable terminals rated connection capacity: rigid/flexible (with and without wire-end ferrules): 0.25 mm2 ... 2.5 mm2 for multiple-wire connection with two wires of equal cross-section: flexible with twin wire-end ferrules: 0.5 mm2 ... 1.5 mm2 | |
Материал | ||
Корпус | PA 66-FR | |
Масса | 170 g | |
Mounting | DIN rail |
Совместимое оборудование | Наименование |
VBP-HH1-V3.0-KIT | AS-Interface Handheld with accessory |
VAZ-PK-1,5M-V1-G | Connection cable module/hand-held programming device |